Scanning on the ImageRunner 3570

If the screen is black, touch the ON/OFF button.
If you don't see the login screen, touch the yellow Reset button.
Enter the dept. ID. For scanning, it is 11111.
Enter the password. For scanning, you can leave this blank.
Push the ID button on the keypad to log in.
You should see the green Send screen. If not, press the Send button along the top of the screen.

Do not push the SCAN button, you will quickly see that this is not the correct mode.

Press the Email button
Press the Email address button
Enter the recipient's email address using the onscreen keypad. (Note: addresses within cs.umd.edu do not need to be fully qualified. For example, smith is assumed to be smith@cs.umd.edu).
Press OK
Press OK again to accept the email address
You may repeat this process to add additional email recipients, or you may add FTP destinations using the instructions below.
(optional) To change the message subject, file name, or other advanced email options, press Send Settings

Press the File button.
Ensure that Protocol is set to FTP.
Press Host name
Enter the target FTP server using the onscreen keypad. (Note: addresses within cs.umd.edu do not need to be fully qualified. For example, ftp is assumed to be ftp.cs.umd.edu).
Press Path
Enter the upload path on the target FTP server using the onscreen keypad.
Press User
Enter the username to use to log into the FTP server. Most anonymous FTP servers will accept ftp.
Press Password
Enter the password to use to log into the FTP server. Most anonymous FTP servers will accept your Email address, some will accept a blank password.
Press OK to accept the FTP destination settings.
(optional) To change the file name to upload, press Send Settings
You may repeat this process to add additional FTP destinations, or you may add email recipients using the instructions above.

Select the File format you want. The Default is PDF. If you want a high-resolution (but very large) scan for editing or photofinishing, you may prefer to use TIFF.
Select the resolution you want. The default is 200 dpi. Remember that the scanner can do black and white only, not color.
If you are scanning multiple pages that you would like to be sent as individual files (one for each page), select the Divide into pages button.

Load your paper face up in the document feeder
Adjust the paper guides to fit the paper if necessary
If you are scanning double-sided documents, be sure to select the Two-sided originals option. It will prompt you to tell it on which edge the pages are flipped.
To cancel the two-sided original option, just select it again and hit Cancel.
Push the Start button.

The document will be scanned and sent.

Place the first page face down on the glass.
Press the Start button.
After the first page is scanned, a dialog box will appear. Adjust paper size if necessary.
Repeat until you have scanned all pages
Press OK

The document will be sent.

The scan settings are reset to the defaults after each job completes, but it is not necessary to re-enter all your Email or FTP information.

If you want to run another scan with the same settings and recipients as a previous scan, the same recipients, just press the recall button.

Press Recall 1 to recall the settings from the last job, Recall 2 to recall the settings from two jobs ago, etc.

After recalling previous settings, you may make changes to them as necessary.

When finished scanning documents, push the ID button to log out.